Payment & Shipping Terms:
|Name:||Crystal & Diamond Micro Dermabrasion||Model:||T12|
|Keywords 1:||Microdermabrasion Acne Scars||Keywords 2:||Dermabrasion For Scars|
|Keywords 3:||Diamond Microdermabrasion||Keywords 4:||Acne Scar Treatment|
|Keywords 5:||Acne Scar Removal||Keywords 6:||Crystal Dermabrasion|
Crystal & Diamond Micro Dermabrasion Facial Skin Rejuvenation Machine
1. Crystal Microdermabrasion
Crystal Microdermabrasion provides a non-surgical skin refinish procedure by using sterile micro-
crystals to abrade or rub off the top skin layer , then vacuuming out the particles along with any
dirt and dead skin .This procedure removes skin debris , imperfections , blemishes , wrinkles and
unwanted pigmentation on the skin . The unit has a special feature , which is the ability to vacuum
back the remaining crystals on the skin . Moderateusage of Micro Dermabrasion , accompany with
skin products that penetrate through top skin layer and reach thedermis level , helps to replenish
natural nutrients , restore cell activity , and promote skin health . The results afterMicro Dermabrasion
treatment is usually a healthy , glowing, beautiful skin.
2. Diamond Dermabrasion
By using sterile diamond heads to abrade or rub off the top skin layer, then vacuuming out the
particles along with any dirt and dead skin back up.
1 . Improve duck yellow , oily skins , remove skins deep dirt
2 . Improve skins rough , acne , pock , rough pores.
3 . Tint color speckles , tiny wrinkles , wrinkles , pock and etc.
4 . Promote the skin metabolism
5 . Decontaminate skin and deeply clean the old cutin.
6 . Improvement skin quantity and elasticity.
7 . Promote blood circulation of skin , improve skin cells tissue
Crystal Micro dermabrasion
120# crystal powder,
Inlet Capacity : 4.1/4.7
Max. Vacuum 150/150mbar
End Pressure : -650mm-hg
Max Capacity : 3.3 M3 /h 60Hz
3.0 M3 /h 50Hz
Vacuum Pressure :750mmhg(100Kpa)
Voltage 100V-120V, 220V-240V
1. crystal flow and vacuum pressure are controlled separately , make it simple and accurate to administer the peeling process and thus reduces any chance to cause discomfort,
2. this new system has been improved so no jam occurred in the crystal flow system and eradicated hence foot pedal is no longer required in this new model.
3. perfect design of the runningrod, with four holes, one releasing and the other recycling the crystal power , so as to avoidblocking the pipe and prevent to much powder remained on the surface.
4. A dehumidifier is attached to back of the equipment , it can avoid block caused by damp of powder.